Make sure the power is off before installation (on some mills, the drive pin holes do not line up with the. Make sure the power input is in the range of product spec to avoid damage
How to Use Servo Motor (sg90 ) With Arduino Nano Project : 6 Steps
Avoid the installation environments where water or oil is accessible
Remove the standard table stop pieces and install the table stop pieces furnished
Put the standard stops back in a position to prevent feed stops from being set beyond extreme table travel. The servo 150 power feed on my new acquired series 1 bridgeport started acting up and i noticed the power switch/circuit breaker was loose and kept pushing into the unit. Hi, the servo 150 power feed on my new acquired series 1 bridgeport started acting up and i noticed the power switch/circuit breaker was loose and kept. Power feed installation step 1
